Stage I 4" Lift

4" Suspension lift system for Jeep TJ 1996-2006. This System comes complete with Progressive rated coil springs front and rear for greatly improved suspension travel and vehicle control

Features progressive rate coil springs, 150-PSI nitrogen shocks and extreme strength laser-cut components! Top of the line strength and attention to detail will make for one superior ride in your TJ or JK! Designed specifically for do-it-yourself installation Components are not only rugged and dependable but look good, too! JK kit includes: progressive rate coil springs front and rear; 4 Cage nitrogen shocks; extended front sway bar links; front lower bump stop extensions; rear track bar; rear sway bar link relocation brackets; rear bump stop blocks; alignment cams front caster/pinion and rear pinion. Kit includes manufacturer's limited lifetime warranty.

97-06 Wrangler, all (includes six speed upgrade kit)

97-04 Wrangler, 2005 Wrangler with Automatic Transmission only

The Future of Bump Shocks - JounceShocks‚
Benefits
- Eliminate suspension bottoming
- Increase stability and improve handling at all speeds
- Enhance rock crawling ability - Improve towing stability and load capacity

You Need It...
Double your suspension capacity in:
- Off-Road Racing - Rock Crawling
- Rock Racing - Stock Trucks
- Lifted Trucks - Fleet Vehicles
- Recreational Off-Road

RaceRunner's Air Shock is just what the doctor ordered for the extreme rock crawler.

4˝ Rock Ready Long Arm Suspension System Skyjacker Suspensions now offers a 4˝ Long Arm kit for the Jeep Wrangler TJ.

Tubular Radius Arms Multi-piece for improved articulation, ride quality and ease of installation. Includes two front cast units that are positioned on the back side of the axle and bolt to the existing front C caps from the stock radius arms. Click Details at right for more information



Also available with optional Solid Axle Swap Brackets for Dana 60 or other solid axles not equipped with "C" bushing mounts.
Brackets flat top allows for mounting 66-79 type Ford 4x4 coils, 80-96 TTB coils, coil over type shock or even air shocks. Holes shown in the brackets are for inserting polyurethane bushings (included in the radius arm kits). These bushings provide for greater axle articulation through the dissipation of axle torsional twist over a broad surface area.
1/4" laser cut side plates are designed to provide for a 7 degree angled mount (similar to a 66-79 Ford) which helps clear large tires during turning yet still bolts right up to our radius arms.
1.5" wide to bolt to CAGE radius arms and to facilitate easily welding to short side axle tubes such as those found on many Dana 60 front axles.